Blog Post

  • rdrewdecor

How to Hang (Paste the Wall) Wallpaper

This is a how to guide for hanging Non-Woven wallpaper/paste the wall wallpapers.



Non-Woven wallpaper is an easy to hang "Paste the wall" product. Do not paste the wallpaper. Before hanging, check that rolls are undamaged, that the product code and batch number are the same for each roll and that all colours match. Please check which way up the design should be and if in doubt, speak with your retailer or view images online.

Check the label included with your rolls for the match point.


Straight Match

The wallpaper matches edge to edge with the next drop to form the pattern repeat.






Random Match

The wallpaper can be matched edge to edge at any point.






Half Drop

The wallpaper is lowered on the second drop to create a diagonal effect pattern repeat.






Tools

You will need the following:


• Paste

• Dust sheet or floor protection • Paste brush or roller • Sharp knife or snap off blade • Spirit level • Clean sponge & bucket of water • Smoothing brush or plastic smoother • Tape measure • Straight edge or metal ruler • A pencil • Scissors • Soft cloth • Felt or soft roller • Steps/Platform


Walls

To ensure a perfect finish, walls should be prepared correctly; all holes should be filled, walls should be smooth, dry and cleared of any debris. Walls must be cross lined with lining paper. Lining paper helps to even out slight imperfections acting as a base for your wallpaper. Do not hang over glossy or non-porous areas. Painted walls should be rubbed down to remove grease and glossy paint should be rubbed down with sandpaper.

Pre-paste porous wall surfaces such as plasterboard or chipboard. Never hang over new plaster or un-primed walls. If lining paper is being installed it should always be hung horizontally, following manufacturer’s instructions, and be allowed to dry completely.



Getting started

Where in the room to begin:


If you are wallpapering a feature wall you can start in the centre of the wall. If a traditional room, work away from the light (wall next to the window wall).


First Drop

The most important step is making sure the first drop (strip of wallpaper) is straight and level. This will affect all other drops of wallpaper on that wall, so it is vital to spend time getting the first drop correct. 


This process of ensuring the first drop is straight should be repeated on starting each new wall. Don’t assume your walls are perfectly straight. 

Measure out from the left hand corner of the wall the width of the paper minus 1cm and mark with a pencil.


Place a spirit level at this mark and draw a straight, vertical line top to bottom on the wall. (This is your plumb line).


Measure the height of your wall, add 10cm (5cm top and bottom) for waste and cut your first drop of wallpaper. If you have selected a design with a bold pattern, consider where you wish the motif to be positioned before cutting. It is important to position the motif carefully at the top of the wall, as this will be clearly visible. 

Once your first drop is ready, apply your paste to the wall using a roller and brush.  Paste the walls generously and evenly.


Only apply paste one drop wide plus 10-20cm. Do not apply paste to the whole wall, as it will dry and become dry and unusable. Paste as you go, pasting just wider than the drop you are hanging.

Any excess paste on the ceiling, skirting etc. should be gently removed with a clean wet sponge before it is allowed to dry.


Being careful not to crease it, loosely roll your first drop so the top and back of the wallpaper is on the outside. Making sure the pattern is the correct way up, apply your first drop to the wall, letting the wallpaper overlap 5cm at the ceiling, and 1 or 2cm at the adjoining wall.


Hold the wallpaper at the top and move into a straight position using your plumb line as a guide. Whilst the paste is wet you can slide the top of wallpaper into the perfect position so it lines up on the plumb line. Unroll your drop along the plumb line, leaving 5cm at the bottom.


Using the wallpaper brush or smoothing tool, working top to bottom gently press the strip to the wall. Remove any air pockets by smoothing out from the middle towards the sides of the wallpaper.


Wash off excess paste on the ceiling, skirting and wallpaper with a damp sponge and clean water. Do not allow any paste to dry on the surface of the wallpaper. 

Using your straight edge and a sharp knife trim the excess wallpaper along the ceiling and skirting. For a perfect finish always use a sharp knife or blade and make the cut in one clean movement. 


Subsequent Drops

Once the first drop is in place, paste the next section of the wall, 10-15cm over one drop wide. Before cutting the next drop, ensure you have allowed for the pattern match as well as 5cm extra top and bottom.


Hang your second drop of wallpaper as per the first, using the edge of the first drop as your guide. Joins should be tightly butted and never overlap. Avoid squeezing paste out of the joints. Wash off any excess paste after hanging each drop with a clean wet cloth.

If necessary, you can then use a seam roller for the seams. Hands should be kept clean and dry.If the edges of the wallpaper do not stick to the wall properly, you need to apply more paste in those areas. Carefully apply paste under the edge with a small brush, being careful not to stretch the wallpaper. 


Corners

Working around the room one drop at a time, ensure each new wall is treated as per the first drop, and hung straight using a spirt level. Corners should be wallpapered using two separate drops. One drop should overlap the adjacent wall by 1 or 2cm, the other should be lined up into the corner. Do not attempt to push wallpaper into a corner. 

Plug sockets & light switches


Ensure the power is off. Plug sockets and light switches should have the facia removed, wallpaper should be laid over the top, carefully cut a cross diagonally from corner to corner. The excess can be cut in at the sides using a sharp knife and metal ruler. The rest of the drop must be firmly in place before light switches or plug sockets are cut in. 


Drying

Allow the wallpaper time to dry slowly at room temperature; do not attempt to dry it quickly as shrinkage may occur. 


Paste

We recommend using a ready mix wallpaper adhesive with no PVA in it. Where wallpaper rolls or drops are numbered the hanging should be done in sequence to create the panel design.


Reverse Hanging

Grasscloth and silk wallcoverings should be reverse hung with alternate lengths in sequence. This helps achieve a more even spread of colour or texture across the wall.


Wallpaper Symbols



And finally...

Drew Decor are a proud member of Which? Trusted Traders and the Painting and Decorating Association and have been Painting and Decorating Sheffield homes for a good number of years with an excellent reputation.


You can see our customer reviews HERE.


If you would like a proper Painting and Decorating team to decorate your home in Sheffield, please get in touch today. GET A QUOTE.


Thank you for reading our blog. You can help us write more blogs and providing helpful decorating tips by subscribing to our website, or by following us on FacebookInstagram or Twitter.


If you are looking for decorators in Sheffield try Drew Decor painters and decorators in Sheffield. We are the go to decorators in Dore, decorators in Totley, decorators in Fulwood, decorators in Ranmoor, decorators in Lodge Moor, decorators in Bradway, decorators in Crosspool, decorators in Sandygate, decorators in Sheffield.



50 views
Painters and Decorators

© 2019 Drew Decor

Drew Decor is the business name of R. Drew Decorators Limited, registered in England and Wales No. 09103934.

Registered Office: 14 Scammadine Close, Rotherham, S60 5JL.

VAT Registration Number: 271543410

Email: rdrewdecor@gmail.com

Tel: 07825767514

Logo and website proudly designed by Matt Lowe Design.